Operator Manual

OPERATION
42
T17 9020160 (5−2014)
WHILE OPERATING THE MACHINE
Pick up oversized debris before scrubbing. Pick
up wire, string, twine, large pieces of wood, or any
other debris that could become wrapped around
or tangled in the brushes.
Drive in a straight a path as possible. Avoid
bumping into posts or scraping the sides of the
machine. Overlap the scrub paths by several
centimeters (a few inches).
Avoid turning the steering wheel too sharply when
the machine is in motion. The machine is very
responsive to the movement of the steering wheel.
Avoid sudden turns, except in emergencies.
Adjust the machine speed, brush pressure, and
solution flow as required when scrubbing. Use the
lowest brush pressure and solution flow settings
for best performance.
If poor cleaning performance is observed, stop
cleaning and refer to MACHINE
TROUBLESHOOTING in this manual.
Perform the Daily Maintenance Procedures after
each use (see MACHINE MAINTENANCE in this
manual).
Drive the machine slowly on inclines. Use the
brake pedal to control machine speed on
descending inclines. Scrub with the machine up
inclines rather than down inclines.
FOR SAFETY: When using machine, go slowly
on inclines and slippery surfaces.
Do not operate machine in areas where the
ambient temperature is above 43 C (110 F). Do
not operate scrubbing functions in areas where
the ambient temperature is below freezing 0 C
(32 F).
FOR SAFETY: When using machine, do not
scrub on ramp inclines that exceed 8.7%
grade or transport (GVWR) on ramp inclines
that exceed 12% grade.