Operator Manual

OPERATION
46
T17 9020160 (5−2014)
ES (EXTENDED SCRUB) MODE − MANUAL
TANK FILL
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, set parking brake, and remove key.
1. Open the solution tank cover.
2. Fill solution tank with water (not to exceed
60°C / 140°F). Fill the solution tank with water
until the level is approximately 25 mm (1 in)
below the opening.
3. Close the solution tank cover.
4. Fill the recovery tank to just above the top of
the ES filter with water (not to exceed 60°C /
140°F).
5. Close the recovery tank cover.
6. Fill the detergent tank with detergent.
WARNING: Flammable materials can
cause an explosion or fire. Do not use
flammable materials in tank(s).
AUTO−FILL (OPTION)
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, set parking
brake, and turn off machine.
1. Lower the Rear bumper door / step.
2. Connect the hose from the water source (not
to exceed 60°C / 140°F) to the auto−fill
connection.
3. Turn the Key switch to the on position and turn
on the water source. The auto−fill
automatically fills the tank(s) to the proper
level(s).
WARNING: Flammable materials can
cause an explosion or fire. Do not use
flammable materials in tank(s).
ATTENTION: For ES Scrubbing, only use
recommended low−foaming cleaning
detergents. Machine damage due to the use of
improper detergent will void the
manufacturer’s warranty.
4. Raise the Rear bumper door / step.