Operator Manual

OPERATION
51
T17 9020160 (12−2019)
SCRUBBING − STANDARD PANEL
FOR SAFETY: Do not operate machine, unless
operator manual is read and understood.
1. Turn on the machine.
2. Press the 1−STEP button. The light near the
button will come on. All of the preset scrub
functions will turn on.
3. If necessary, activate the scrub mode
required for the area to be cleaned.
4. If necessary, adjust the brush pressure and
solution flow.
5. Place the Directional switch in the forward
position.
6. Press the Propel pedal to begin scrubbing.
NOTE: DO NOT turn on the ec−H2O system
during conventional scrubbing. Conventional
cleaning detergents could cause an ec−H2O
system failure. Drain, rinse, and refill the solution
tank with cool clean water before operating the
ec−H2O system.
ec−H2O machines only: A flashing red light
located on the bottom portion of the LED
(light−emitting diode) light directly above the
ec−H20 button indicates when the ec−H2O
system needs to be flushed. See ec−H2O
MODULE FLUSH PROCEDURE in the
MAINTENANCE section.
WARNING: Flammable materials or
reactive metals can cause an explosion
or fire. Do not pick up.
FOR SAFETY: When using machine, go slowly
on inclines and slippery surfaces.
NOTE: The squeegee automatically rises when
the machine is driven in reverse. This prevents
damage to the squeegee.
7. Release the Directional pedal and press the
brake pedal to stop the machine.
8. Press the 1−STEP button to stop scrubbing.
The light near the button will go off and
scrubbing functions will stop after a short
delay.
NOTE: If there is a fault code or warning code
during machine operation (flashing warning / fault
indicator light, a code displayed on the LCD, and
an audible alarm), stop the machine and refer to
the FAULT INDICATORS or WARNING CODES
section of this manual for the cause and the
corrective action for eliminating the fault or
warning.