Operator Manual

OPERATION
52
T17 9020160 (3−2019)
SCRUBBING − PRO−PANEL
FOR SAFETY: Do not operate machine, unless
operator manual is read and understood.
1. Start the machine.
2. If applicable, log into the machine. See
PRO−ID LOGIN SCREEN.
3. If applicable, complete the Pro−Check Pre−
Operation Checklist. See COMPLETING THE
PRO−CHECK PRE−OPERATION
CHECKLIST.
NOTE: Make sure the scrubbing modes / settings
are set before scrubbing.
4. Press the 1−STEP button. The 1−STEP
button and all other selected scrubbing /
sweeping buttons will illuminate.
5. If necessary, adjust the scrubbing brush
pressure and solution flow.
If necessary, activate the scrub mode or zone
setting required for the area to be cleaned.
6. Release the parking brake.
7. Place the directional switch in the forward
position.
8. Press the propel pedal to begin scrubbing.
NOTE: DO NOT turn on the ec−H2O system
during conventional scrubbing. Conventional
cleaning detergents could cause a ec−H2O
system failure. Drain, rinse, and refill the solution
tank with cool clean water before operating the
ec−H2O system.
WARNING: Flammable materials or
reactive metals can cause an explosion
or fire. Do not pick up.
FOR SAFETY: When using machine, go slow
on inclines and slippery surfaces.
NOTE: The squeegee automatically rises when
the machine is driven backwards. This prevents
damaging the squeegee.
9. Press the rearview camera button at any time
to check cleaning performance behind the
machine.
10.Release the directional pedal and press the
brake pedal to stop the machine.
11.Press the 1−STEP button to stop scrubbing.
The button will no longer be illuminated and
scrubbing / sweeping functions will stop after
a short delay.
NOTE: If there is a fault or alert code during
machine operation, stop the machine and refer to
the FAULTS / ALERTS section of this manual for
the cause and the corrective action for eliminating
the fault or alert.