Operator Manual

OPERATION
59
T17 9020160 (5−2014)
DRAINING AND CLEANING THE SOLUTION
TANK
Machines equipped with ES (Extended Scrub)
only: Drain and clean the solution tank daily.
Clean the outside of the tank with vinyl cleaner.
1. Drive the machine near a floor drain.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, set parking brake, and remove key.
2. Lower the rear bumper door / step.
3. Remove the solution tank drain hose from the
solution tank.
4. Hold the drain hose near a floor drain, twist
the drain nozzle open, and place the hose
near the floor drain.
NOTE: Be sure the drain hose nozzle is pointed in
a safe direction before opening the nozzle.
5. If necessary, twist the drain nozzle to another
position to adjust the flow rate.
6. Twist the handle and lift the solution tank
cover open and flush out the solution tank
with clean water. Rinse the ES filter located at
the bottom of the tank.
NOTE: DO NOT use steam to clean the tanks.
Excessive heat can damage the tanks and
components.