Operator Manual

OPERATION
61
T17 9020160 (12−2019)
FAULT INDICATORS / WARNING CODES
The operator will receive a fault / alert warning
when there is a mechanical / electronic issue with
the machine.
All fault codes are accompanied by an audible
alarm to alert the operator a fault has occurred.
To reset the fault / alert indicators, turn off the
machine and then eliminate the cause of the fault
/ alert. The fault / alert indicator will reset when
the machine is restarted.
NOTE: Lithium−ion battery model − To clear fault
code, turn key switch off and wait up to 3 seconds
for machine power to completely shut off. Then
turn key switch back on again.
Refer to the fault / alert indicators table to
determine the cause and remedy for the fault /
alert.
FAULT / ALERT INDICATORS − STANDARD
PANEL
This machine is equipped with two visual
indicators, a red indicator light and an LCD (liquid
crystal display).
The red indicator light will blink continuously
indicating that a fault has occurred.
The LCD will display a fault code. If there is more
than one fault, each fault code will alternately
display.