Operator Manual

OPERATION
69
T17 9020160 (3−2019)
HIGH PRESSURE WASHER (OPTION)
The high pressure washer is used for heavy duty
cleaning. Do not use detergent in the solution tank
when using the pressure washer or pressure
washer damage could occur.
NOTE: Before using the high pressure washer for
the first time or if the solution tank was completely
drained, prime the high pressure washer pump.
See PRIMING THE HIGH PRESSURE WASHER
PUMP.
FOR SAFETY: When servicing machine, do
not power spray or hose off machine near
electrical components.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, set parking brake, and remove key.
1. Turn off the machine and set the parking
brake.
NOTE: The high pressure washer will not operate
unless the parking brake is set.
2. Unlatch the hose tie down and remove the
pressure washer hose from the machine.
3. Unlatch the pressure washer wand tie down
and remove the wand from the machine from
the machine.
4. Connect the hose to the high pressure washer
system.
5. Connect the other end of the hose to the
wand.
6. Adjust the nozzle on the wand to the desired
setting.
Pull the nozzle out for the Low pressure
setting, or push the nozzle in for the High
pressure setting. Twist the nozzle for either
the Stream or Fan setting.
7. Start the machine.