Operator Manual

OPERATION
71
T17 9020160 (3−2019)
PRIMING THE HIGH PRESSURE WASHER
PUMP
The high pressure washer pump needs to be
primed before operating for the first time or if the
solution tank was completely drained. To prime
the system, the solution pump must be run to
bring water/solution to the high pressure washer
pump before operating the high pressure washer
pump.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, set parking brake, and remove key.
1. Turn off the machine and set the parking
brake.
2. Chock the rear wheels.
3. Connect the hose and wand to the high
pressure washer system.
4. Start the machine.
5. Release the parking brake.
NOTE: This prevents damaging the high pressure
pump from operating with no water/solution in the
pump.
6. Press the top of the High pressure washer
switch to activate the solution pump. The light
on the switch will come on when the high
pressure washer is turned on.
7. Squeeze and hold the trigger until
water/solution flows out the wand.
8. Release the trigger.
9. Press the bottom of the high pressure washer
switch to turn off the high pressure washer.
10. Turn off the machine and set the parking
brake.
11. The high pressure washer pump is now
primed.