T300e Operator Manual

OPERATION

Tennant T300e (02- 2017)

Dual disk model - Turn the brush motor hub until

the lug slot with spring clip is visible. Position the

three lugs into the motor hub slots and give the pad

driver/brush a quick turn towards the spring clip

(Figure 11). View through the scrub head window to

align lugs.

NOTE: The left and right disks engage the hubs in

opposite directions.

FIG. 11

4. Single disk model - To remove the pad

driver/brush, grip the disk and give it a quick turn in

the direction as shown (Figure 12).

FIG. 12

Dual disk model - To remove the pad driver/brush,

grip the disk and give it a quick turn in the direction

as shown (Figure 13).

FIG. 13

INST ALLING BRUSH/PAD - Insta-Click Magnetic

Disk (Option)

FOR SAFETY: Before leaving or servicing machine,

stop on level surface, turn off machine, remove key

and set parking brake if equipped.

W ARNING: Magnetic Field Hazard. Magnetic

pad driver/brush can be harmful to pacemaker

wearers or medical implants.

1. Step down on the scrub head lift pedal to raise the

scrub head off the floor (Figure 14).

FIG. 14

2. Attach the pad to the pad driver before installing

the driver (Figure 15). Secure pad with centerlock.

FOR SAFETY: Do not operate machine with pads

or accessories not supplied or approved by

Tennant. The use of other pads may impair safety.

FIG. 15

3. Place the pad driver/brush under the scrub head

and lift into position. The Insta-Click pad

driver/brush will automatically click into position

(Figure 16).

FIG. 16