T300e Operator Manual

OPERATION
14
Tennant T300e (02- 2017)
2. Remove the debris tray by sliding it out from the
scrub head (Figure 23).
FIG. 23
3. Remove the idler plate from the scrub head by
unscrewing the yellow knob (Figure 24).
FIG. 24
4. Slide the brushes into the scrub head and connect
the slotted ends of each brush into the drive hubs
(Figure 25).
FIG. 25
5. Connect the idler plate to the brush ends and
reattach the idler plate. Make sure the idler plate
hooks are engaged before tightening knob (Figure
26).
FIG. 26
6. Replace debris tray.
FILLING SOLUTION TANK
FOR SAFETY: Before leaving or servicing machine,
stop on level surface, turn off machine, remove key
and set parking brake if equipped.
Remove the solution tank lid and fill the solution tank.
Stop filling tank when the level reaches the “3/3” mark
on the solution tank drain hose indicator (Figure 27).
ec-H2O Scrubbing - Fill solution tank with only cool
clean water (less than 70°F/21°C). Do not add
conventional floor cleaning detergents. An ec- H2O
system fault will occur if cleaning detergents are added.
Conventional Scrubbing - Fill solution tank with
water (not to exceed 60°C/140°F). Pour a
recommended cleaning detergent into the solution tank
according to mixing instructions on the container.
NOTE: Do not use the ec-H2O system when there are
conventional cleaning detergents in the solution tank.
Drain, rinse, and refill the solution tank with clear cool
water before operating the ec-H2O system.
Conventional cleaning detergents will cause an
ec- H2O system fault.
W ARNING: Flammable materials can cause an
explosion or fire. Do not use flammable materials
in tank(s).
ATTENTION: For Conventional Scrubbing, only use
commercially approved cleaning detergents. Machine
damage due to improper detergent usage will void the
manufacturer’ s warranty.
FIG. 27
The solution tank fill- port is equipped with two hose
clips to hold hose while filling. The two clips are
different hose diameter sizes (Figure 28).
FIG. 28