T300e Operator Manual

OPERATION
16
Tennant T300e (03- 2015)
To install the accessory clips, hook the clip over the rail
and push downward until it snaps into position. To
remove the accessory clip, reach under the clip and
carefully pull the latch tab downward to release from
rail. (Figure 33)
FIG. 33
The optional accessory clips allow for storage of wet
floor signs, spray bottles, squeegee assembly, debris
bags and other items (Figure 34).
FIG. 34
ATTENTION: Do not use the accessory
rails to lift machine, damage may occur.
ATTENTION: Do not step on accessory
rails, damage may occur.
MACHINE OPERATION
FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
PRE-OPERATION CHECK LIST
- Sweep area and remove any obstructions.
- Check brushes/pads for wear and damage.
- Check squeegee blades for wear and damage.
- Confirm recovery tank empty and screen and
debris tray is clean.
- Check scrub head skirt for wear and damage.
- Cylindrical brush model - confirm scrub head
debris tray is empty and clean.
- ec-H2O Scrubbing: Confirm solution tank is filled
with clear cool water only.
- ec-H2O Scrubbing: Ensure all conventional
cleaning agents/restorers are drained and rinsed
from solution tank.
- Check machine for proper operation.
OPERATING MACHINE
1. Release the parking brake lever , if equipped (Figure
35)
2. Turnthekeytotheon(I)position(Figure35).
FIG. 35
3. ec-H2O models - The ec-H2O system will
automatically turn on at start up. To turn off the
ec-H2O system, press the ec-H2O switch located
below the key switch (Figure 36).
ATTENTION: During first time use and after replacing
the water conditioning cartridge, the ec-H2O system
will automatically override the selected solution flow
rateforupto75minutes.