User's Manual

Manual KeyReader Plus
Manual
KeyReader Plus
TeraTron GmbH
Page 4 of 12
Document Version 1.0
Date: 19.07.2016
Autor: Frank Bajahr
Manual_KeyReaderPlus.doc
1 Introduction
The KeyReaderPlus is a portable Device which is capable of reading data stored in dedicated vehicle
keys. Once the data have been read the data are transferred to a remote server. The transfer takes
place via Wifi or the USB Interface.
Delivery Content
KeyReaderPlus Handheld
USB-Cable
The user(s) of these products are cautioned to only use accessories and peripherals approved, in
advance, by MANUFACTURER. The use of accessories and peripherals, other than those approved
by MANUFACTURER, or any changes or modifications not expressly approved by the party responsi-
ble for compliance could void the user’s authority to operate the equipment.
Installation
The KeyReader Plus should be completly charged before the first operation. Charging is done by con-
necting the KeyReader Plus to a USB-port or USB-Power Supply which is capable to deliver at least
500mA. The Micro-USB-Connection at the KeyReader Plus is coverd by a sliding bar.
As soon as the KeyReader is connected to the power supply the device is booting up. The LED is
giving the battery status.
Indicator and Operating Elements
The KeyReader Plus has 3 RGB-LEDs, which are giving a feedback on ist actual working condition.
The LEDs are marked with a Symbol. There is one LED for the vehicle key reading function (symbol :
Key), one for the connection state of the server (symbol: waves) and one for the battery status (sym-
bol: battery).
At the opposite side is are, covered by a sliding bar, the Micro-USB-Connevtor and a small switch.
With this switch the KeyReader Plus can be switched off by holding it down for min of 2 sec. After the
switch is released the KeyReader Plus will drive down. This is indicated by the flashing blue “Key”-
LED.
In case the KeyReader Plus needs tob e set back to inital factory state the button has to be pressed
for > 10 sec. A Factory Reset is performed and all configuration settings and memory is set back.
Via the micro-USB-connection the KeyReader Plus can be cahrged. Furthermore the initial settings
can be made via this Interface.