Quick start Guide

CONNECT TO CUBE
STREAM TO THE INTERNET
Connect power to Cube using the included A/C adapter or one of the available accessory power cables
(see Teradek.com).
Connect to Cube’s Wi−Fi network: Teranet−XXXXX (serial number of the device).
Plug an Ethernet cable into Cube’s 10/100/1000 Ethernet port and connect it to an Ethernet switch
or router.
Open Cube’s web UI, Select the Video Stream Output menu if it is not already displayed.
Connect the SDI or HDMI output from your video source to one of Cube’s video input connectors (J).
Open a web browser and navigate to http://172.16.1.1, or find Cube using Bonjour.
Connect your computer to the same network. Cube’s IP address is displayed on the front panel’s Ethernet
Status menu, access it by pressing down on the Menu joystick to cycle through status screens.
Select Internet Streaming as the Stream Mode and choose a platform − Facebook, Ustream, Livestream,
YouTube, Twitch − or select manual RTMP.
Select your desired Audio/Video bitrate and resolution under the Encoder menu.
Cube’s Wi−Fi can be configured to join your network via the web UI or front panel.
Open a web browser and navigate to Cube’s IP address, or find Cube using Bonjour.
Enter your credentials and choose a channel/event, or enter the RTMP destination info and press apply.
Go Live by clicking the Broadcast button
, or use the front panel Stream Joystick
Cube has a built in web interface for configuring stream destinations, encoder parameters,
and other settings. The interface can be accessed by connecting via Wi−Fi or wired Ethernet.
PHYSICAL CONNECTIONS
1
2
3
1
1
1
1
2
2
2
2
4
3
3
3
5
WI−FI
CONNECT TO A WIRED NETWORK
NEED MORE HELP?NEED MORE HELP?
1. Support: http://support.teradek.com → Contains tips, information and all the latest firmware & software updates.
TERADEK SUPPORT STAFF: [e-mail] or call 888−941−2111 ext2 (Mon−Fri 9am to 6pm PST)
1. Support: http://support.teradek.com → Contains tips, information and all the latest firmware & software updates.
TERADEK SUPPORT STAFF: [e-mail] or call 888−941−2111 ext2 (Mon−Fri 9am to 6pm PST)
600 series
A
B
H
K
F
E
D
C
Stream Joystick:
● (button press): Access quick menu actions, exit menu screens
Menu Joystick:
▲,▼, ▲ , ▲ : Select menu items, change status screen on main display, select characters
● (button press): Confirm selection, open selected menu
Reset Button:
Hold for 3−6 seconds: Reset all network settings
Hold for 10+ seconds: Perform complete factory reset
A: Wi−Fi Antenna
B: Video input status
C: Encoder status
D: Broadcast status
E: SD/MMC Card slot
F: Fault/Error
G: OLED display
H: Stream Joystick
I: Menu Joystick
J: SD/HD/3G−SDI and HDMI inputs
K: 10/100/1000 Ethernet
L: Reset button
M: Power Switch
N: Power Input
O: 1/8" Headphone output
P: Mic/Line stereo input
Q: USB Port
A
P
Q
I
O
N
G
J
J
L
M
CUBE 600 QG.indd 1 3/20/17 2:44 PM