Quick start Guide

A: On/Off switch
B: Mini USB port
C: 6-28V DC input
D: HDMI output
E: 3G-SDI output
F: OLED display
G: Status joystick
H: Menu joystick
I: Battery plate
NEED MORE HELP?
Support: http://support.teradek.com → Contains tips, information and all the latest firmware & software updates.
TERADEK SUPPORT STAFF: [e-mail] or call 888−941−2111 ext2 (Mon−Fri 7am to 6pm PST)
PAIRING INSTRUCTIONS
CONNECT AND POWER
After powering the transmitter and receiver, connect a monitor to the video output.
Connect the output from your video source to the SDI/HDMI input on the Bolt 3000 transmitter.
Connect the SDI/HDMI output from the Bolt 10K receiver (E, D) to the video input on your monitor.
Bolt 10K is an ultra long-range
wireless receiver for the most
demanding cinema, broadcast,
and UAV applications. Bolt 10K
receivers support 1080p60
4:2:2 video at up to 10,000 ft
line−of−sight from a Bolt 3000
transmitter.
Confirm that "Please activate pairing on TX" is displayed on Bolt 10000
receiver’s output.
Using the Menu joystick on the receiver, select “OK” to finish pairing. This process takes up
to a minute. If pairing fails, power cycle the receiver and the transmitter and try again.
On the transmitter, use a paper clip (or similar) to press the Reset/Pair
Mode button (J). After a few seconds, the receiver should display Pairing:
BP00XXXX. If not, power cycle the receiver and the transmitter, then try
again.
Move the power switches on both the transmitter and receiver (A) to the ON position.
Using the Menu joystick (H) on the receiver, select “Pairing.”
Connect power to the Bolt transmitter. Power the Bolt receiver with the included A/C adapter or
optional battery plate accessory. If using a battery plate, connect a compatible
(AB Gold mount or V-Lock) battery.
1
1
3
5
4
3
2
2
A
C
D
E
A
J
Teradek regularly releases new firmware versions to improve performance, add new features, or to fix vulnerabilities.
Visit https://www.teradek.com to update your device with the latest firmware.
H
GF
B
B
C
D
E
DEVICE OPERATION
GENERAL
MOUNTING
• Keep the transmitter and receiver at close range for 60 seconds after powering on the devices.
This allows them to scan for and select the best wireless channel.
• For best results when using multiple Bolt systems in the same area, place the transmitters and
receivers a few feet apart from each other.
• Operation of other wireless equipment may interfere with the Bolt. For best results, separate other
wireless transmitters and receivers as much as possible.
• Bolt 10000 has a 3/8 in threaded hole on the bottom for mounting the included light stand adapter
or any 3/8 in mounting accessory.
• Mount the receiver vertically, keeping the antennas clear of any obstructions.
• Orient the transmitter and receiver so they are parallel to each other.
• For best results, orient the receiver so the front has clear line−of−sight to the transmitter.
ULTRA LONG-RANGE
WIRELESS HD VIDEO
I
Bolt 3000 TX