Quick Start Guide

Press the REC button on the controller (C) to start/stop recording on the camera.
2
NOTE: If using a RED camera, the camera serial communication setting must be set to RCP
(Redlink Command Protocol) for the unit to operate.
Connect a camera cable from the CAM/Control port on the receiver to the camera, then navigate
to MENU>CAMERA on the CTRL.3 to indicate which camera you have connected.
1
CAMERA RUN/STOP
4
Press the MENU button, then use the ▲, ▼ and SET button to navigate through the dierent
menu options.
• POWER OFF - Power OFF the controller
• LENS - Congure lens mapping function
• MOTORS - Congure attached motor(s)
• INPUTS - Congure controller’s knobs/slider
• WIRELESS - Congure wireless settings
• CAMERA - Select the make of the camera
• LIMIT - Congure knob’s range
• SCREEN - Change display settings
• BUTTONS - Assign functions to the buttons
• RX CONFIG - Congure auxiliary controllers,
such as a thumbwheel or zoom rocker
• ADV - Contains device info menu, licenses,
and advanced functions for debugging
CONTROLLER MENU OPERATION