Quick Start Guide

6
Press the MENU button, then select TABLE DONE. You will then be prompted to create an iris or
focus distance table, depending on the type of lens. Select YES.
6
7
Using the Up and Down buttons on the controller, enter the corresponding mark, then select OK.
Repeat for all marks until they have all been mapped to the controller.
Move the controller knob so that the motor adjusts the lens ring to the smallest mark.
5
Repeat steps 5 through 7 for each motor you want to map
8
10
Navigate to LENS>LENSRING>SELECT and select the corresponding lens ring size.
Attach a lens ring to the controller’s knob.
9
For prime lenses you will be prompted to create an Iris table. For zoom lenses, you will be
prompted to create a focal length table, then an iris table after. Make sure a motor is attached to the
corresponding ring, and both the motor and controller are set to the same class (Focus, Iris, Zoom).
4