Instruction Manual

© 2 0 1 4 . T e r a d e k , L L C P a g e | 10
Streamer
 Mode – Select P2P mode when streaming to a client via WiFi or to a single receiver on a LAN. Select Multicast when
streaming to 2-4 Beam receivers wirelessly or to many devices over a multicast-enabled wired network.
 Encapsulation – Select RTP when streaming to a Beam RX or when the RTSP server is enabled. Select UDP TS when
using MPEG-TS to a compatible decoder.
 RTSP Server – Enabling this allows multiple clients to pull the stream from an encoder using the RTSP stream mode.
Audio
 Mode – Select Stereo, Mono, or Disabled for the primary embedded audio stream.
 IFB – Select Enabled to allow for two-way stereo talkback communication.
Factory Default – To reset all settings to their factory default values, select this menu, and then select Reset All Settings. The
device reboots after the configuration is reset.
Beam RX
Decoder – Use this menu to set the decoder ID value. When streaming from one Beam TX to multiple Beam RX units, each RX
must be configured with a different ID. There are four different IDs available.
WiFi – This menu allows you to configure the WiFi SSID and channel, or to enable Ethernet LAN mode. See the encoder WiFi
menu description for the available options.
Streamer
 Mode – Select P2P mode when streaming point-to-point over WiFi or a LAN. Select Multicast when connecting to a
multicast encoder. If multicast is selected, the Group IP can be configured via the web UI.
 RTSP Server – Enabling this allows multiple clients to pull the stream from a decoder using the RTSP stream mode.
Audio
 IFB – Select Enabled to allow for two-way stereo talkback communication.
Factory Default – To reset all settings to their factory default values, select this menu, and then select Reset All Settings. The
device reboots after the configuration is reset.