Instruction Manual

Streaming Control

Item

Description

Streaming Interface

Current streaming interface: WiFi or Ethernet LAN. This can be configured via Beam’s

Front panel.

Streaming Mode

Select P2P mode when streaming over WiFi, or when connecting point-to-point over a

LAN. Select Multicast when connecting to a multicast encoder.

Peer IP (LAN)

In P2P mode, set the Peer IP to the encoder’s IP address.

Group IP (Multicast)

In Multicast mode, set the Group IP to match the address configured at the Beam TX.

Audio Intercomm

Select On to allow for two-way stereo talkback communication.

RTSP Relay Server

Enabling this allows multiple clients to pull the stream from a decoder using the RTSP

stream type. When enabled, video from the encoder is re-streamed to clients on the

same network as the Beam RX. Beam RX will relay video and re-stream video

simultaneously.

RTSP Streaming Mode

Select whether to use Unicast (P2P) or Multicast for the decoder’s RTSP server. When

multicast is enabled, the RTSP stream is still available at

rtsp://192.168.0.162:8554/stream (replace the IP address with the decoder’s Ethernet

LAN or WiFi address, not the multicast group IP).