Instruction Manual
© 2 0 1 4 . T e r a d e k , L L C P a g e | 1
1. Introduction
1.1 About this Manual
This user manual provides step-by-step instructions for the setup and configuration of Beam.
1.2 Overview
Beam is a WiFi-equipped H.264 encoder for applications demanding high quality, low-latency video transmission. Beam can transmit
to up to 4 decoders over WiFi or an unlimited number on a wired network using multicast. Beam supports SD/HD/3G-SDI video
inputs with embedded stereo audio and bidirectional stereo IFB communication. Beam can stream video in RTP and MPEG-TS
formats, re-stream from the decoder, and more.
1.3 Features
Video
High performance SD/HD/3G-SDI transmission over Wi-Fi or Ethernet LAN (IP)
H.264 encoding/decoding engine: Baseline profile level 4.2 with de-interlacing
Full HD encoding up to 1920x1080p60
Streaming server function on both Beam TX and Beam RX
Very low encode/decode end-to-end latency in 1080i59.94 HD: 70ms ~ 80ms
Single video stream + stereo audio
SDI/HD-SDI/3G-SDI supported for PAL, NTSC and full HD video
Supports DTV Standards
o SMPTE 244, BT601 (NTSC): 525i59.94
o IEC61179-5, BT601 (PAL): 625i50
o SMPTE 296M: 720p23.98, 720p24, 720p25, 720p30, 720p50, 720p59.94, 720p60
o SMPTE 274M: 1080i50, 1080i59.94, 1080i60, 1080PsF23.98,1080PsF24, 1080PsF25, 1080PsF29.97, 1080PsF30,
1080p23.98, 1080p24, 1080p25, 1080p29.97, 1080p30, 1080p50, 1080p59.94, 1080p60
Supported bitrates : 100kbps - 30Mbps over Wireless, 50Mbps over Ethernet
Error resiliency : Variable GOP size, random intra-refresh, contiguous intra-refresh, I-frame control
Audio
SD/HD/3G-SDI embedded audio
Mini-stereo phone jack in and out for analog stereo audio
Analog stereo audio: 48kHz sampling with 16 bit ADC
Wireless IFB audio from TX to RX and from RX to TX with 8kHz sampling and 16bit ADC
Network
Wireless Output for Audio/Video : Supporting IEEE 802.11n/5GHz
Wide radio coverage up to 800m (2,500ft) with 12Mbps at line of sight
Ethernet port for audio/video transmission: Ethernet LAN (10/100 BASE-TX, Cat.5e UTP cable)
1 TX to 1 RX connection or 1 TX to 4 RX connections on wireless mode