Instruction Manual

© 2 0 1 4 . T e r a d e k , L L C P a g e | 4
1.4.1 Front and Rear panel of Beam TX
Front View
Item
Component
Description
1
Power (LED)
This LED shows the power status
2
Video (LED)
This LED shows the SDI video input signal status. This LED illuminates
when video is present and the TX is encoding
3
Link (LED)
This LED shows the link status. This LED illuminates when a valid client is
connected
4
Fault (LED)
This LED illuminates during boot up, or if an error occurs
5
OLED Display
The OLED display contains multiple status and configuration screens.
These can be navigated using the Status (6) and Menu (7) joysticks. The
main status screen (shown) displays the WiFi or Ethernet status at top
left, the device mode, video resolution (if connected), and the encoder
bitrate
6
Status Joystick
Use the status Joystick to cycle between Beam’s status screens. Separate
screens contain information about the WiFi, Ethernet, video resolution,
and firmware version
7
Menu Joystick
Use the menu joystick to view and modify Beam’s configuration
8
RS-422
RS-422 interface (See section 3.7 for pin description)
9
LAN
RJ-45 Ethernet LAN port