Owner manual

A: Status LEDs

B: Menu Joystick

C: Stream Joystick

D: WiFi Antennas

E: LAN/WAN

F: Antenna Connectors

G: A/C Input

H: Reset Button

I: SIM Card Slots

Menu Joystick:

▲,▼: Select menu items, select characters

: Back, move to higher menu level

,● (button press): Confirm selection, open selected menu

Stream Joystick:

● (button press): Cycle status screens on main display, cancel (back),

switch text entry mode

▲

POWER & CONNECT

SPUTNIK SERVER

Enter the menu on Edge’s front panel ( ,●), select the Sputnik menu,

select Host, and then use the onscreen input to enter your Sputnik

server’s IP address or host name. Select OK to set the value. Please see

the Sputnik set up guide for Sputnik installation information (Available

at http://teradek.com/pages/downloads).

SPECIFY YOUR SPUTNIK SERVER’S ADDRESS

▲

H I

Attach cellular antennas to the SMA antenna connectors (F).

Insert compatible SIM cards (I).

Connect A/C Cable to (G), Edge turns on automatically when

power is connected.

Attach WiFi antennas if desired to the RP−SMA connectors

labeled 2.4/5Ghz (D).

CONNECT YOUR ENCODER TO EDGE

Connect Cube to Edge’s wireless network (default Edge-1234, where 1234

is replaced with the last four digits of your Edge’s serial number):

PAGE 1
A B C E D G A: Status LEDs B: Menu Joystick C: Stream Joystick F H I D: WiFi Antennas E: LAN/WAN F: Antenna Connectors G: A/C Input H: Reset Button I: SIM Card Slots ▲ Menu Joystick: ▲,▼: Select menu items, select characters : Back, move to higher menu level ,● (button press): Confirm selection, open selected menu ▲ Stream Joystick: ● (button press): Cycle status screens on main display, cancel (back), switch text entry mode 1 POWER & CONNECT 1 Attach cellular antennas to the SMA antenna co
PAGE 2
▲ 1. Enter the main menu by pressing or ● (using the menu joystick). Select Network Setup with ▼ and enter the menu with . 4. From the Infrastructure menu, choose Scan. ▲ 5. Select Edge’s network. 2. Select Configure. 6. Choose Yes to Apply the new Network settings. 3. Select Infrastructure. 7. Set your Cube’s Bonding mode to Edge, found in the menus under A/V Setup > Bonding > Mode. CONNECT VIA ETHERNET 1. Connect Ethernet interface 1 (E) to a switch or router. 2.