User's Manual

GC1000-03-00559 (REV. 01) PAGE 6 OF 7
Figure 4
STEP 6
If you are going to use the Infrared Sensor (G), attach the female end of the
Infrared Sensor cable to the Sensor bulkhead fitting (see Figure 4) of the
1030/1040 Gateway (A) as shown in Figure 5.
S
TEP 7
If you are going to use the Ethernet port on the Gateway, first unscrew the
Ethernet Dust Cap from the Ethernet Bulkhead Fitting (see Figure 4). Attach the
Ethernet Crossover Cable (F) to the Ethernet Bulkhead Fitting as shown in
Figure 5.