User Manual

Table Of Contents

TeraHop Networks IMS Installation and Operation Manual V1.1 08-0000-01-R1

116

Shock

The Shock sensor is used to determine when an asset has been struck with a predetermined

force. The enabling of this sensor, its sensitivity, along with the number of shock events to

issue an alarm is configurable under the Shock tab. The Report Frequency is a setting that

defines the amount of time (in seconds) that must pass before another event alarm is sent to

the user application. It is recommended that this setting remain at four (4), which will issue

an alarm no more often than once every four (4) seconds.

To configure the Shock sensor, do the following:

1. Click the Shock tab.

2. To enable Shock under this Behavior Profile, override the Enable Shock Event label and

select the Enable Shock Event check box.

3. In the same manner, override the Shock Sensitivity radio buttons selection.

4. Click to select the desired Sensitivity level radio button.

Note: it is recommended that the default sensitivity be selected until ample field experience

is obtained to justify a more or less sensitivity selection.