User Manual

Configuring the System
117
Check-in
The Check-in is used to specify the frequency at which the RSN checks in with the TeraHop
network to confirm its presence. Depending on the behavior profile, a more frequent check-
in rate may be desired. For example, a First Responder asset assigned to a dangerous task
would want a faster check-in rate than one in Re-hab.
To configure the Check-in parameter, do the following:
1. Click the Check-in tab.
The Check-in selection should always be enabled, and the only parameter that should be
configured is the Check-in Frequency.
2. To change the Check-in, override the Check-in Frequency drop-down box.
3. In the Check-in Frequency field, click the drop-down arrow and select the desired
check-in frequency from the drop-down list of values.
8.2.11 Saving the Configurations
It is recommended that you save the configuration changes after each tab has been edited.
However, saving more often is a good policy. Also note that should at any time it be
required to return to the original default parameters, this can be achieved, prior to the
changes being saved, by selecting the Undo Changes button at the bottom of the middle
section.
To save a configuration, click the Save Configuration button located at the bottom of the
right-hand panel.