User Manual

Configuring the System
125
To wake up an RSN, do the following:
1. Remove the plug from the underside of the RSN.
2. Swipe the RSN indent next to the cradle indicator to activate the Magnetic Reed Switch.
The cradle indicator looks like a two-headed arrow embossed on the top of the cradle.
3. Place the RSN in the RCT Cradle so that the hole in the RSN fits snugly over the 16-pin
connector on the cradle.
You should see the Heartbeat LED light (#4 illustrated below).
You should then see the NETWORK, TRANSMIT, and RECEIVE LEDs light in that
order (numbers 1, 2, and 3 in the illustration below). When the LEDs light, you know that
the RSN is good.
Figure 19: RCT Cradle LEDs