User Manual

TeraHop Networks IMS Installation and Operation Manual V1.1 08-0000-01-R1
144
Reset - to reboot the RSN. Do this when you want to use the RSN. If you reset the RSN,
it will not appear on a network until you download a configuration to it.
Sleep - sleep mode. Use this when you want to put the RSN on a shelf for future use.
When you want to use the RSN, you will need to awaken it. See How to Wake Up or
Troubleshoot an RSN.
Shutdown - Shut down (power cycle) - turn the RSN off. Use this when you want to turn
off the power to the RSN by depressing the black power switch inside the RSN plug
cavity (see illustration below) for several seconds and then releasing it. Power cycling the
RSN takes the RSN out of service. To recover, hold the power switch down for several
seconds and then release it.
9. Click Download Factory Default.
The RSN has been set to its factory defaults, and depending on your selection, is either in
deep sleep, has been reset, or has been shut down.
10. Remove the RSN from the RCT Cradle and insert the plug cover using the plug cover
screws.