User Manual

TeraHop Networks IMS Installation and Operation Manual V1.1 08-0000-01-R1
8
To install the IMS hardware and software, follow the process outlined below.
• Using the RCT, wake up one RSN. (See How to Wake Up an RSN in this manual.)
• Using the RCT, program one RSN with the customer ID. (See How to Configure
RSNs in this manual.)
• Perform a System Bench Check: hook up the system with all hardware connected
using a 12V power supply. You can do a system bench check with the factory
defaults. It should show up with a customer ID of 70. (See Operational Checkout and
System Commissioning in this manual.)
• Configure the real Customer ID (as assigned by TeraHop Networks) in the MMR.
(See How to Edit the Customer ID and AcceptFirstResponder Options in the MMR in
this manual.)
• Configure the Wi-Fi SSID on the GR. (See Updating the Gateway Router Access
Point Configuration in this manual.)
• Update the PDA Wi-Fi with access point SSID – update the Config File. (See
Updating the PDA Software, Step 3 Set PDA System Configuration and Wi-Fi SSID
in this manual.)
• Configure the PDA with sectors/divisions, profiles, and incident types using the ACT.
(See Configuring the IMS Application in this manual.)
• Configure the rest of the RSNs with configurations (parameters) and user data. See
Configuring RSNs in this manual).
• Download RSN configurations to the RSNs. (See Configuring RSNs in this manual.)
• Configure the Administration Station (ADMS) with Wi-Fi SSID (see Setting the
ADMS SSID to Connect to the Mobile Gateway System (MGS)).
• Retest the entire system on the bench.
• Install the system in the vehicle. (See Hardware Installation
in this manual.)
• Test in the vehicle – run the operational checklist procedure. (See Operational
Checkout and System Commissioning in this manual.)