User Manual

TeraHop Networks IMS Installation and Operation Manual V1.1 08-0000-01-R1
16
Data Definition
Level
Note: The movement and shock features can be enabled or disabled by the system.
Different "behaviors" can be set for different RSN status or work assignment settings.
5.4 Maintenance Philosophy
This manual supports operational, intermediate and depot levels of maintenance. See
below for an abbreviated explanation of each level of maintenance.
Operational This level of maintenance includes all preventive and corrective
maintenance that an end user or customer could perform. Performance
of this level of maintenance requires no special tools or test equipment.
Intermediate This level of maintenance can only be performed by specially trained,
TeraHop certified technicians. This maintenance is typically limited to
circuit card assembly replacement, computer assisted setup and
calibration of a recently installed network prior to commissioning.
Depot This level of maintenance shall always be performed at a remote site. It
will likely be performed at the manufacturing facility or any TeraHop-
approved facility. Depot location will also be the site for failed
equipment disposition.
5.5 Safety Introduction
This section serves as a single location where the reader can locate the safety
admonishments that are applicable to the content contained in this document. Keep in
mind that every admonishment contained in this section is a duplicate of an
admonishment that is located immediately before the task or procedural step that poses
the potential hazard.