Installation Guide
Installaon guide Alex 1580x500mm - SX
Please read the instrucons in full before starng to fit your radiator.
• Please check that all parts listed are present before starng installa-
on.
• Valves are not provided, please make sure that you have them
before you start. This product requires standard 1/2" radiator valves.
• Before drilling holes for the brackets please check that there are no
hidden wires or pipes.
• The plugs supplied are for hard walls masonry only. Please make
sure you are using the correct plug for your wall.
• Terma radiators are designed for closed heang systems.
• The radiator should be fied at least 100 mm from the floor to
maximise heat efficiency.
• Nong the distances between bracket centres, mark out the
posion of the brackets on the wall.
• Drill holes to approximately 80 mm depth using a 10 mm drill bit
and insert rawl plugs (1). Using connecng screw with a washer (2)
aach mounng bracket-1 (3).
• Using bracket to collector fixing screw (5) aach mounng
bracket-2 (6) to radiator.
• Guide all mounng brackets-2 (6) into mounng brackets-1 (3) and
fix with connecng screws (4)
• Connect the water flow using appropriate 1/2" BSP valves. Follow
valves manufacture guidelines for correct installaion.
• Fill the radiator and purge any trapped air via the bleed valve at the
top of the radiator.
• Wipe your radiator down using a clean damp cloth.
Never use scourers or abrasives.
For all installaon and warranty enquiries please
contact Crimson Bear Customer Support on
01535 636256
Refers to water and dual fuel version
2
2
3
0
30
SX
5
7
÷
6
5
470
1
5
8
0
500
9
0
1
4
0
0
132 ÷ 140 470
G1/2"G1/2"
Fixing kit content
rawl plug
wall fixing
screw +
washer
mounng
bracket-1
bracket
connecng
screw
bracket to
collector
fixing screw
mounng
bracket-2
air vent
allen key
(1)
(2)
(3)
(4)
(5)
(6)