Users Manual

3DJH
5HY&

6&$17(55DGDU6\VWHP
7HFKQLFDO0DLQWHQDQFH0DQXDO
+7
 :DUQLQJVDQGVDIHW\LQVWUXFWLRQV
7KHIROORZLQJRXWOLQHVEDVLFZDUQLQJVDQGVDIHW\LQVWUXFWLRQVZKHQZRUNLQJRQWKH
UDGDUV\VWHP)XUWKHUZDUQLQJVDQGVDIHW\LQVWUXFWLRQVFDQEHIRXQGLQGRFQR
+7³:DUQLQJVDQG6DIHW\,QVWUXFWLRQVIRU7HUPD5DGDU$QWHQQD6\V
WHPV´
In no event, Terma A/S shall be held liable for any direct, indirect, punitive, incidental or consequential damages what-
so-ever arising out of or connected with the use or misuse of its products.
Only access for authorized personnel.
Always use the safety switch to stop transmission and the rotating antenna, before accessing
the antenna platform. A rotating antenna may cause injury or even death.
Always wear climbing harness when accessing a radar tower. Observe and follow local safety
regulations. Inform the relevant people of the work to be performed.
ACCESSING THE ANTENNA INSTALLATION
WARNING
SAFETY
FIRST
WARNINGS,
CAUTIONS AND
SAFETY
INSTRUCTIONS
AUTHORIZED
PERSONNEL
ONLY
CAUTION
Radar safety sheet - 679071-QA
CAUTION
Never stand in front of an open-ended waveguide or coax from which power may be radiated.
The transceiver produces non-ionising electromagnetic radiation. On a non-faulty system, only
the antenna radiates. Radiation could be dangerous for the human body and precautions
should be taken.
High voltage may be present at several points of the equipment, even with equipment
switched off. Observe and follow all electrical safety precautions. These voltages may cause
injury or even death.
Antenna, transceiver, computers and instruments must be connected to the same electrical
protective ground.
Always use ESD (Electrostatic Sensitive Device) precautionary procedures when handling
ESD marked modules. The equipment contains components sensitive to damage by
electrostatic discharge. Wrist strap connected to earth bonding point must always be used
when handling unshielded electronics. Modules must be stored in static shielding packaging
(EIA-541). Module repair must be done on a ESD workstation, by qualified personnel.
Use only non-magnetic tools when working with magnetrons.
MAINTENANCE OF THE RADAR SYSTEM
CAUTION
WARNING
WARNING
)LJ :DUQLQJVDQGVDIHW\LQVWUXFWLRQV