Operation Manual

The iron is supplied with a self-cleaning system which allows
limestone deposits to be reduced. To obtain full benefit from
this system, carry out this operation regularly at least once
a month.
Do as follows:
• Set the dry ironing function.
• Fill the tank up to the MAX level (11).
• Let the iron run and bring the soleplate to the maximum temperature.
• When the iron is ready, disconnect the plug from the power outlet.
• Set the steam control dial (4) to the symbol of the self-cleaning
function, shake the iron in a horizontal position over a sink or a
basin until the tank is empty. The water and steam mixture will
eliminate a part of the limestone residues that are present in the
soleplate.
SELF-CLEANING SYSTEM
 ENGLISH
To “liven up” the clothes hung on cloth hangers, curtains,
etc. you can use the iron vertically:
• Set the temperature control knob (9) to the MAX position.
• Hold the iron in a vertical position at a distance of about 15-20 cm
from the fabric.
• Press the super-steam button (4) several times.
NOTE
• Do not press the super-steam button too many times consecutively.
Observe pauses of some seconds between one operation and the
following one.
IMPORTANT
• Do not use this function on fabrics made up of synthetic fibres.
• Keep an adequate distance between the fabric and the iron soleplate
in order to avoid burns.
• Use this function only on clothes hung on clothes hangers. Do not
try to iron clothes if they are worn by a person: the steam is very
hot, you could cause serious burn injuries.
VERTICAL IRONING