Operation Manual

To enable this function, press the super-steam button (4) several times: the iron
will supply an instantaneous high power steam jet.
• Do not press button (4) too many times consecutively, as this may cause non-steamed
water drops to be discharged.
• Use this function only with the temperature control knob (12) set to symbols , max.
• When the super-steam function is used for the rst time some limestone pieces could
come out. We therefore recommend not to discharge the rst steam jets directly onto
the linen.
This system prevents the iron from dripping onto the linen. The device is automatically
enabled if, for whatever reason, the temperature of the soleplate lowers.
The ionization process generates small steam particles that percolate deeply
into fabrics and allow removing even the most resistant creases. As a matter of
fact, when this function is enabled the iron delivers steam, but it is less thick than that
generated during a normal steam ironing.
To enable this function do as follows:
• Fill the tank with water.
• Set dial (12) to symbols , max.
• Choose the desired steam output by turning the steam control dial (4).
• Press the IONO button (7).
To disable the ionization function, press again the IONO button (7).
NOTE: The ionization function can be enabled only after setting the ironing using steam
at high temperature.
To “liven up” the clothes hung on cloth hangers, curtains, etc. you can use the
iron vertically:
• Set the temperature control knob (12) to the max position.
• Hold the iron in a vertical position at a distance of about 15-20 cm from the fabric.
• Press the super-steam button (4) several times.
SUPER-STEAM FUNCTION
ANTI-DRIP SYSTEM
IONIZATION FUNCTION
VERTICAL IRONING
SPRAY FUNCTION
• This function allows moistening the linen during both steam and dry ironing.
• To enable it press the spray button (5) several times and direct the water jet onto the
most resistant creases.