Instruction manual

If problems continue, please contact TERMOZETA Service Centre.
Fit the hot milk blender (3).
Fill pot (8) with water up to the maximum level for hot milk MAX .
Press the ON/OFF push button (11) twice.
The appliance starts working: it heats and mixes the water in such a
way to remove any milk residues from the pot.
At the end of this operation, empty the pot and remove the remaining
residues with a soft sponge to avoid the pot teflon coating to be
damaged.
Wash blenders (2), (3) and (4) and lid (1) with hot water and dishwashing
detergent. Never wash these parts of the appliance in the dishwasher.
To clean the appliance body, use a damp sponge only.
IMPORTANT!
• Never immerse the appliance in water or other liquid substances
and never put it under running water.
• Never use abrasive or chemical products.
• Make sure the appliance is completely dry before putting it away.
PROBLEM
SOLUTION
Pilot lights (9) and/or (10) do not
turn on and the appliance does
not warm up even after pressing
push button (11)
Make sure the appliance is connected to the power
supply
The appliance does not make
any froth
Make sure the blender for milk froth (2) or (4) is
properly positioned inside pot (8)
Make sure the blender for milk froth(2) or(4) is not
damaged
Make sure pot (8) does not contain anything
preventing the blender for milk froth (2) or (4) from
working
The appliance does not make
enough froth
Make sure milk is fresh; if long life milk is used,
make sure the best before date has not expired
 ENGLISH