Owner's Guide

Note: Power is available whenever the vehicle
is not asleep (for example, when Keep Climate
On, Dog Mode, or Sentry Mode is enabled).
Note: Always use USB 2.0 compliant cables
when connecting devices to the USB ports.
Using non-compliant cables can result in
slower charging and, if plugged into either of
the front two ports, can result in potential
connection problems when trying to access
media files on the device.
Note: Do not connect multiple devices using a
USB hub. This can prevent connected devices
from charging or from being recognized by
Media Player.
Installing Phone Charging Cable
To make it easy to connect your phone while
keeping the console free of clutter, you can
install a phone charging cable in Model 3.
Note: The phone dock supports two phones
side-by-side.
To install a phone charging cable:
1. Open both center console doors in front
of the cup holders.
2. Remove the rubber mat from the phone
dock.
3. Lift the phone dock to access the USB
ports.
4.
Release the cover from the base of the
phone dock by sliding it to the left.
5. Plug the USB connector on the phone
charging cable into a USB port.
6. Insert the phone end of the charging cable
through the bottom of the phone dock
and route the cable through the securing
tabs towards the bottom of the phone
dock.
7. Reinstall the cover to the base of the
phone dock by sliding it to the right.
8. Lower the phone dock and reinstall the
rubber mat.
12V Power Socket
Your Model 3 has a power socket located in
the center console's rear compartment. Power
is available whenever the vehicle is not asleep
(for example, when Keep Climate On, Dog
Mode, or Sentry Mode is enabled).
Interior Storage and Electronics
Opening and Closing 21