User Manual
Table Of Contents
- IMPORTANT SAFETY INFORMATION
- PRODUCT OVERVIEW
- INSTALLATION
- In the Box
- Tools
- Installation Considerations
- Step 1: Prepare Wirebox for Conduit Fittings and Bushings
- Step 2: Prepare Mounting Surface
- Step 3: Prepare Wirebox and Mount to Wall
- Step 4: Route Wiring Through Wirebox
- Step 5: Strip and Land Wiring
- Step 6: Attach Wall Connector to Wirebox
- Step 7: Energize Wall Connector
- COMMISSIONING PROCEDURE
- POWER SHARING
- WALL CONNECTOR LEDS
- WARRANTY INFORMATION
- _
Step 3: Prepare Wirebox and Mount to Wall
1. Use a 1/4 in (6.5 mm) bit to drill two pilot holes into the wirebox that match the locations chosen on
the cardboard mounting template.
Drill bit, 1/4 in (6.5 mm)
Top Entry Bottom Entry Bottom Left Entry Bottom Right Entry
2. Attach the wirebox to the mounting location using the included 4 mm hex bit and the two included
wood fastener screws.
NOTE: Type 3R rating is only possible when washers have sealing gaskets. If mounting to
alternate surface (such as a prefabricated pedestal), use alternate fasteners with sealing
washers.
NOTE: The wood fastener screws are designed to support the weight of the entire Wall
Connector, cable, and charging handle.
INSTALLATION
23Gen 3 Wall Connector Manual