User Manual
Table Of Contents
- IMPORTANT SAFETY INFORMATION
- PRODUCT OVERVIEW
- INSTALLATION
- In the Box
- Tools
- Installation Considerations
- Step 1: Prepare Wirebox for Conduit Fittings and Bushings
- Step 2: Prepare Mounting Surface
- Step 3: Prepare Wirebox and Mount to Wall
- Step 4: Route Wiring Through Wirebox
- Step 5: Strip and Land Wiring
- Step 6: Attach Wall Connector to Wirebox
- Step 7: Energize Wall Connector
- COMMISSIONING PROCEDURE
- POWER SHARING
- WALL CONNECTOR LEDS
- WARRANTY INFORMATION
- _
COMMISSIONING PROCEDURE
The commissioning process for Wall Connector enables easy configuration of circuit breaker size, Wi-Fi
connectivity, and power sharing options.
1. Turn on Wall Connector's corresponding branch breaker to energize the unit.
During startup, Wall Connector will display green LEDs for 10 seconds to indicate the maximum circuit
breaker it is configured for.
2. Use a Wi-Fi-enabled device such as a smart phone to connect to the SSID Wi-Fi signal broadcasted by
the Wall Connector. Joining the Wall Connector network can be done by scanning the sticker QR code
on the Quickstart Guide cover page, or by manually selecting the network and typing in the WPA2
password (found on the sticker on the Quickstart Guide cover page).
NOTE: The Wi-Fi network will broadcast for 15 minutes.To have the Wall Connector broadcast
the SSID again, hold the button on the charging handle for 5 seconds or turn the circuit breaker
o, then on again.
NOTE: If you are unable to connect to the Wall Connector SSID, turn o the cellular data
function on your mobile device and try again.
3. Scan the QR code below with the device that is connected to the Wall Connector to access the web
browser commissioning interface. Alternatively, manually type the URL address (http://192.168.92.1)
into the web browser.
4. Follow the onscreen commissioning steps on the web browser to assign Wall Connector to its own
circuit breaker and connect it to the local site Wi-Fi network.
28Gen 3 Wall Connector Manual