User Manual
Table Of Contents
- IMPORTANT SAFETY INFORMATION
- PRODUCT OVERVIEW
- INSTALLATION
- In the Box
- Tools
- Installation Considerations
- Step 1: Prepare Wirebox for Conduit Fittings and Bushings
- Step 2: Prepare Mounting Surface
- Step 3: Prepare Wirebox and Mount to Wall
- Step 4: Route Wiring Through Wirebox
- Step 5: Strip and Land Wiring
- Step 6: Attach Wall Connector to Wirebox
- Step 7: Energize Wall Connector
- COMMISSIONING PROCEDURE
- POWER SHARING
- WALL CONNECTOR LEDS
- WARRANTY INFORMATION
- _
NOTE: To have the Wall Connector broadcast the SSID again, hold the button on the charge
handle for 5 seconds or turn the circuit breaker o, then on again.
Setting Up Access Control
The Charging Access Control feature provides full control over which vehicles are allowed to charge with
your Wall Connector and excludes vehicles without access based on user specifications.
1. Sign into the commissioning wizard..
Use the Commissioning Procedure on page 28 to sign into the commissioning wizard and connect to
the Wall Connector Wi-Fi SSID by clicking on the 'Access Control' card.
2. Configure Access Control.
You can choose from three options:
◦ 'All Vehicles'
This is the default option and will allow charging on all electric vehicles with a matching charge
port. To charge with the older generation Tesla Roadster, you will need to pick the 'All Vehicles'
option
◦ 'Only Tesla'
This option blocks charging on non-Tesla EVs.
◦ 'Authorized Teslas Only'
This option allows you to add up to 10 specified Tesla cars by their VIN and assign an optional
name. For convenience, the VIN of the last 10 cars previously connected to the Wall Connector is
made available for selection. The VIN is usually displayed on your windshield and can also be
found in the 'Software' tab on your vehicle touchscreen.
COMMISSIONING PROCEDURE
29Gen 3 Wall Connector Manual