User Manual
Table Of Contents
- IMPORTANT SAFETY INFORMATION
- PRODUCT OVERVIEW
- INSTALLATION
- In the Box
- Tools
- Installation Considerations
- Step 1: Prepare Wirebox for Conduit Fittings and Bushings
- Step 2: Prepare Mounting Surface
- Step 3: Prepare Wirebox and Mount to Wall
- Step 4: Route Wiring Through Wirebox
- Step 5: Strip and Land Wiring
- Step 6: Attach Wall Connector to Wirebox
- Step 7: Energize Wall Connector
- COMMISSIONING PROCEDURE
- POWER SHARING
- WALL CONNECTOR LEDS
- WARRANTY INFORMATION
- _
POWER SHARING
Power Sharing Overview
The firmware-based power sharing feature enables up to 6 Wall Connectors installed at the same site to
intelligently share the site's total available power via unit-to-unit Wi-Fi. This minimizes the need for many
residential and commercial applications to have specific electrical upgrades for concurrent multi-vehicle
charging.
During the commissioning process,
• Wall Connectors are allocated to individual branch circuits (each up to 60 amps)
• Total power is allocated to the group of linked Wall Connectors
NOTE: For instructions to commission Wall Connectors in a power sharing network, see Gen 3 Wall
Connector Power Sharing.
Total current output of Wall Connectors that share power will never exceed the site's total allocated power.
1. AC feed (service panel)
2. Power sharing via Wi-Fi communication
31Gen 3 Wall Connector Manual