User Manual
Table Of Contents
- IMPORTANT SAFETY INFORMATION
- PRODUCT OVERVIEW
- INSTALLATION
- In the Box
- Tools
- Installation Considerations
- Step 1: Prepare Wirebox for Conduit Fittings and Bushings
- Step 2: Prepare Mounting Surface
- Step 3: Prepare Wirebox and Mount to Wall
- Step 4: Route Wiring Through Wirebox
- Step 5: Strip and Land Wiring
- Step 6: Attach Wall Connector to Wirebox
- Step 7: Energize Wall Connector
- COMMISSIONING PROCEDURE
- POWER SHARING
- WALL CONNECTOR LEDS
- WARRANTY INFORMATION
- _
NOTE: In the event that your leader and followers have dierent circuit breakers, you have to
individually connect to each of the followers on dierent breakers via the Wi-Fi broadcast, and
then set the correct breaker limit.
NOTE: For example, in a four Wall Connector network with two 60 amp breakers, one 50 amp
breaker and one 20 amp breaker where the leader has a 60 amp breaker, individually connect
to the Wall Connectors with 50 amp and 20 amp breakers and set their current limit in the
commissioning interface using the Commissioning Procedure on page 28.
4. Enable power sharing network.
Once your power sharing network is fully established (followers paired and network limit set), you will
have the ability to enable the network.
NOTE: No units in the network will be able to charge the connected vehicles if the power
sharing has not been enabled.
POWER SHARING
35Gen 3 Wall Connector Manual