User Manual
Table Of Contents
- IMPORTANT SAFETY INFORMATION
- PRODUCT OVERVIEW
- INSTALLATION
- In the Box
- Tools
- Installation Considerations
- Step 1: Prepare Wirebox for Conduit Fittings and Bushings
- Step 2: Prepare Mounting Surface
- Step 3: Prepare Wirebox and Mount to Wall
- Step 4: Route Wiring Through Wirebox
- Step 5: Strip and Land Wiring
- Step 6: Attach Wall Connector to Wirebox
- Step 7: Energize Wall Connector
- COMMISSIONING PROCEDURE
- POWER SHARING
- WALL CONNECTOR LEDS
- WARRANTY INFORMATION
- _
WALL CONNECTOR LEDS
Light Codes
Startup
Once energized at the circuit breaker, every LED (seven total) on the faceplate will illuminate for up to five
seconds.
After Startup
After Wall Connector is energized at the circuit breaker, certain green LEDs (depending on the circuit
breaker size) will illuminate for 10 seconds. See table below for exact light codes.
Circuit breaker 60 A 50 A 40 A 30 A 20 A 15 A
Maximum output 48 A 40 A 32 A 24 A 16 A 12 A
NOTE: To re-display the green LEDs after the initial 10 seconds, press and hold the charging handle
button.
When multiple Wall Connectors are linked for power sharing, the center blue LED will illuminate during the
10-second startup window.
Other
Standby, waiting to plug
in
Charging in progress
SSID broadcasting, ready
to commission
Waiting to charge,
communicating with
vehicle
Top green solid Every green streaming Green pulsing Blue solid
36Gen 3 Wall Connector Manual