Installation Instructions
Wireless Phone Charger‐ Model WC2
The Model WC2 wireless phone charging mat can charge your Qi‐enabled smartphone at up to 15W of
power. Once installed in the center console phone dock, simply place your smartphone on the mat. The
wireless phone charger supports up to two phones at once, charging side by side. The wireless phone
charger uses the driver‐side USB‐C port.
NOTE: The wireless charger may not work if your phone case is metal. Take the phone out of the case and
place the phone on the charger.
NOTE: Charging two phones at once will take longer than charging one phone, as power must be divided
among the two devices.
FCC and IC Certification
Component Manufacturer Model
Operating
Frequency
(MHz)
FCC ID IC ID
Wireless
charger
Tesla
WC2
2AEIM‐WC2 20098‐WC2
The devices listed above comply with Part 15 of the FCC rules and Industry Canada's license‐
exempt RSS Standard(s) and EU Directive 2014/53/EU.
Operation is subject to the following two conditions:
1.
This device may not cause harmful interference; and
2.
This device must accept any interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by Tesla could void your authority to operate the
equipment
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.