Automobile Parts User Manual

ManualsBrandsTest Products International ManualsAutomobile Parts505

The Value Leader

www.tpi-thevalueleader.com

Test Products International, Inc.

9615 SW Allen Blvd

Beaverton, OR 97005-4814 USA

Ph: 503-520-9197 Fax: 503-520-1225

Test Product International Ltd.

342 Bronte Street South, Unit 9

Milton, Ontario L9T 5B7

Ph: 905-693-8558 Fax: 905-693-0888

Test Products International UK Ltd.

Longley House, East Park

Crawley, West Sussex RH10 6AP

Ph: +44 (0) 1293 561212 Fax: +44 (0) 1293 813465

505 Instruction Manual

505

PHOTO / CONTACT

TACHOMETER

Instruction Manual

Summary of content (4 pages)

PAGE 1
The Value Leader TM www.tpi-thevalueleader.com 505 Instruction Manual Test Products International, Inc. 9615 SW Allen Blvd Beaverton, OR 97005-4814 USA Ph: 503-520-9197 Fax: 503-520-1225 Test Product International Ltd. 342 Bronte Street South, Unit 9 Milton, Ontario L9T 5B7 Ph: 905-693-8558 Fax: 905-693-0888 Test Products International UK Ltd.
PAGE 2
WARNING Read instructions before operating: Be sure these instructions accompany the tool when passed from one user to a new or inexperienced user. Rotating equipment can cause flying particles Wear Safety Goggles (User and bystanders). Flying particles can cause eye injury. Keep yourself, clothing and test equipment clear of moving parts. OPERATION SPECIFICATIONS Function Range Accuracy Photo Tach 6 - 30,000 RPM ± 0.1% of FS + 1 digit Contact Tach 6 - 20,000 RPM ± 0.1% of FS + 1 digit Surface Speed 0.
PAGE 3
BATTERY REPLACEMENT Measurement Procedure: 1. Remove the screw holding the battery compartment cover in place on the back of the 505. 2. Slide the cover off of the unit. 3. Remove the 2 each “AA” alkaline batteries and replace with the same type. 4. Replace the cover and screw. STANDARD ACCESSORIES Reflective Tape . . . . . . . . . . . . . . . . . . . . . . .A501 Contact RPM Adapter (screw on) . . . . . . . . .A502 RPM Adapter (Cone Type) . . . . . . . . . . . . . .A503 RPM Adapter (Funnel Type) . . . . .
PAGE 4
CONTACT TACH OPERATION SURFACE SPEED OPERATION Measurement Procedure: Measurement Procedure: 1. Screw the shaft assembly to the optical end of the 505. 2. Insert the cone or concave wheel that more closely matches the end of the component to be measured on the shaft assembly. 3. Press and hold the START button and then press the Contact button (lower left) on the 505. 4. While pressing the START button, hold the wheel against the end of the rotating shaft.. 5. Read the RPM on the LCD. 1.