User Manual

7
9. Inspection Procedure
a. Connect the BNC output connector to the vertical input of a general purposed
oscilloscope.
b. Connect an appropriate power source to this probe and then turn it on.
c. Set the oscilloscope to DC coupling and 1V/div. Center the trace on the display.
d. Connect the inputs of the probe to power lines.
e. Then, a 50Hz/60Hz sine-wave of proper amplitude will be displayed on the screen of
the oscilloscope and this means the probe is working properly.
10. Cleaning
Use a soft cloth to clean the dirt. Prevent damage to probe.
a. Avoid immersing the probe.
b. Avoid using abrasive cleaners.
c. Avoid using chemicals contains benzene or similar solvents.
Lemo® and Probus® are the registered trademarks
Date: June 1,2004
TESTEC Elektronik GmbH
Westerbachstr. 58
60489 Frankfurt / Germany
Tel.: [phone]
Fax: [phone]
website: www.testec.de
e-mail: [e-mail]