User manual

22
7. Measuring
This chapter describes the steps that are required to perform measurements
with the product.
Particular probes must be plugged in or switched on and registered (radio
probes) according to the variable that is to be measured.
Some probes require a warming-up phase until they are ready to measure.
➣
Taking a measurement:
✓ The instrument is in measurement view.
✓ The measuring program AUTO is not activated (735-2 only).
Put the probe in position and take the readings.
➣
Changing the upper measurement channel line display:
Press .
➣
Changing the lower measurement channel line display, showing the
max./min. value of the variable in the upper measurement channel line:
Press .
- The following are displayed in consecutive order:
· Available measurement channels
· Maximum value of the variable in the upper display line
· Minimum value of the variable in the upper display line
· Lower measurement line not shown
➣
Resetting max./min. values:
The minimum or maximum values of all measurement channels are reset.
1 Press several times until the maximum or minimum value is displayed.
2 Reset the max./min. values with .
➣
Holding readings:
Press .
Press to change back to displaying the actual reading.
➣
Saving readings (735-2 only):
Press .
- A measurement protocol with the readings of all available measurement
channels is created for the active location.
Save
Reset
Act
Hold
7. Measuring