User Guide

34
6. Measuring
This chapter describes the steps that are required to
perform measurements with the product.
 The instrument is switched on and is in measurement
view.
²
Taking aa mmeasurement:
i Put the probe in position and read off the readings.
With the Auto Hold function on:
The Auto Hold function is only active on plug-in
measuring probes.
- Auto Hold flashes during measurement.
- If the reading is stable within the set evaluation
time, a signal tone is given and the reading is
recorded.
i Start measurement again with .
With the alarm function on and if the alarm threshold
is exceeded or not undershot:
- Alarm lights up and a signal tone is given.
- The alarm goes out if the reading goes below the
upper or above the lower threshold again.
²
Changing tthe mmeasurement cchannel ddisplay:
You can change between displaying plugged-in probes
and radio probes ( ).
i To change the display: Press .
²
Holding tthe rreading, ddisplaying tthe mmaximum/minimum
value:
The current reading can be recorded. The maximum and
minimum values (since the instrument was last switched
on) can be displayed.
6. Measuring