User manual

7 Using the product
47
Pos: 31 /TD/Überschr iften/6. Produkt ver wenden @ 0\mod_117377492855 4_79.doc @ 328 @ 1
7 Using the product
Pos: 32 /TD/Erste Sc hritte/testo 175/Fühler anschließen @ 6\mod_12749 57942556_79.doc @ 61981 @
7.1. Connecting a sensor
Observe the following points when connecting sensors to
data logger and measuring points.
> Ensure correct polarity of the plugs.
> Press the plugs firmly into the ports to ensure leak
tightness. However, do not apply force!
> Make sure that the plugs are firmly connected to the
data logger or that the connections are closed with
blanking plugs.
> Ensure correct positioning of the sensor to avoid
disturbing influences affecting the measurement.
> testo 175 T3: Always make sure that you connect the
sensor configured (via the software testo ComSoft) to
the individual sockets. The numbers of the connections
are printed on the housing.
Pos: 33 /TD/Produkt verwenden/testo 174-neu/ Hinweis Datenlogger programmieren @ 5\mod_126 4769275750_79.doc @ 56853 @
7.2. Programming data logger
In order to adapt the programming of your data logger to
your individual requirements, you require the testo
ComSoft 5 Basic software. It is available in the Internet as
a free download requiring registration www.testo.com,
International, Service&Support | Download Center.
The instructions for the installation and operation of
the software can be found in the testo ComSoft 5
Basic instruction manual that is downloaded
together with the software.
Pos: 34 /TD/Produkt verwenden/testo 175/Men üübersicht @ 7\mod_12846 35393673_79.doc @ 72313 @