TR-750 Router User Manual Hardware 2 LEDs 2 Buttons 2 Connections 3 Battery 3 Initial Setup/Configuration 3 Network 4 WiFi 5 System 6 Specs 7 FCC Statement 7 FCC Caution 7 Page 1
Hardware The TR-750 is a dual-band (2.4GHz, 5GHz) battery powered router. LEDs The TR-750 has the following LEDs to provide status (listed left to right): • Ethernet - blinks to indicate Ethernet data transfer • 5 GHz Connection - 5GHz Wifi signal (solid) and data transfer (blinking) • 2.4 GHz Connection - 2.
• Power Button - Press the power button to turn the device on. Press and hold the power button for a few seconds to turn the device off. Press and hold the power button for 15 seconds to force the power off. • Reset Button - Press and hold the reset button for at least 8 seconds to reset the device to factory defaults. Connections • Ethernet - The RJ45 port can act as a WAN or LAN based on the device configuration. • USB - USB devices can be connected to the female USB A port.
Network The network tab allows the user to set the IP address, enable or disable the DHCP server, and switch the Ethernet port mode to LAN or WAN.
WiFi The WiFi settings can be configured in the WiFi tab. The country/region should be set so that the appropriate WiFi channels can be selected. The follow settings can be changed for both the 2.4Ghz and 5GHz networks: enabled/disabled, SSID, password, channel, and SSID broadcast. Both the 2.4GHz and 5GHz networks can join an existing WiFi network as a client. This process can be started by pressing the Configure button.
System The system tab can be used to upgrade or reset the firmware, set the login password, and save or restore router settings. Battery status information is also presented.
Specs CPU MT7628AN & MT7610E Memory DDR2 128MB / Flash 16MB Ethernet 1 RJ45 port (WAN/LAN configurable) USB 1 USB A data, 1 Micro USB charging port Frequency 2.4GHz / 5GHz Protocol 802.11a/b/g/n/ac Transmission Rate 300Mbps (2.4GHz) + 866Mbps (5GHz) Power Supply 5V 2A Power Consumption < 10W Working Temperature 0 - 35 °C Manufacturer: GL Technologies (Hong Kong) Limited, Unit 210D, 2/F, Enterprise Place Hong Kong Science Park, Shatin, Hong Kong - Shenzhen Guanglianzhitong Tech Co., Ltd.
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver.
