User's Manual

•
Power Button - Press the power button to turn the device on. Press and hold the power
button for a few seconds to turn the device off. Press and hold the power button for 15
seconds to force the power off.!
•
Reset Button - Press and hold the reset button for at least 8 seconds to reset the device to
factory defaults.!
Connections
•
Ethernet - The RJ45 port can act as a WAN or LAN based on the device configuration.!
•
USB - USB devices can be connected to the female USB A port.!
•
SD Card - Full sized SD, SDHC, and SDXC can be used.!
•
Charging port - The device may be charged with a micro USB cable. Any standard USB
power source may be used.!
Battery
The TR-750 battery is accessed by sliding off the battery cover on the bottom of the device.
The battery must be inserted in the orientation indicated in the battery compartment or the
device will be damaged. Only official TR-750 batteries should be used.!
Initial Setup/Configuration
Follow the below steps to setup/configure your router.!
1. Ensure the TR750 router’s battery is charged or is being charged and turn on the router.!
2. Connect via LAN or the 2.4GHz or 5GHz WiFi networks. The WiFi network names and
passwords will be listed on the bottom of the device.!
3. Visit http://192.168.8.1 in a web browser to access the router configuration!
4. The default password is admin.!
5. The following screens illustrate the Network, WiFi, and System settings.!
Page 3