Datasheet

• Concept G 850 THX 9
Connecting
Danger
Danger of injury/damage!
Arrange the cables so that they do not pose a
trip hazard.
• Pull the power plug of all devices to be connected out
of the socket to prevent accidental activation.
Subwoofer
4
• Connect the line-in jacks (4) of the subwoofer with the
5.1 output jacks of the sound card, the decoder station
or the DVD player using 6 high-quality RCA cables.
Speakers
8
• Lay the speaker cable from the subwoofer to each
speaker. These cables should be high-quality double-
wire speaker cable with marked strands.
A small tip: Label the cables on the subwoofer side.
This will help when taking down and setting up the
system.
• A terminal with a red and black connector clip is lo-
cated on the back side of each speaker. Here you can
connect the speaker cables directly or with optional
pin plugs. We only describe the direct connection in
these instructions.
Observe the correct polarity!
Connect the like-coloured terminals. Otherwise,
the sound quality will suffer. The strands of the
speaker cables are marked with different colours or
shapes.
• Split the single wire down to approx. 30 mm on both
ends and strip approx. 10 mm of insulation off of each
cord. Twist the single wires together so that no strands
are protruding.
• Turn the connector terminal counterclockwise until
loose. Run the stripped cable end into the now visible
hole. Turn the terminal clockwise until closed. The
cable has now been clamped into place.
• Connect all cables to the speakers in this way.
• Connect the other ends of the speaker cables to the
jacks (8) of the subwoofer in the same manner.
Connecting to a power supply
9
10
• Make sure that the mains switch (9) is set to “Off”.
• Use the power cord  to connect the mains connector
jack (10) with an easily accessible socket.
• Insert the power plug of the connected unit back in the
socket.
• Now turn on the connected unit and set the mains
switch (9) of the subwoofer to On.