Operation Manual

• Cinebar 21 11
Basic functions
Activating and deactivating
• With the Power (1) button or
(22), you can switch
your Cinebar 21 on or to standby. The standby indica-
tor (5) will illuminate in red in standby mode.
Selecting a source
Also see page 10, table 1.
Push the device button Source (2) until the connector
jack of the desired source appears on the display.
On the remote control, select the source with the but-
tons Aux (32) or Optical (23) or Coaxial (25).
The respective setting will appear on the display.
Adjust the volume
On the device: Push the buttons Vol +/– (3).
Using the remote control: Push the buttons +/– (30).
Mute (switching to mute)
You can activate or deactivate the sound by pushing
the button (24) repeatedly.
Adjust the sound
You can only adjust the sound settings with the remote
control only.
Selecting sound effects
Your Cinebar 21 is equipped with Dolby Virtual Speaker
technology. This simulates the audio impression of a 5.1
surround sound system using the soundbar.
Two sound effects are possible:
– The surround sound effect: Reference
– An effect that makes the distance between the speak-
ers appear greater: Wide
If necessary, push the Surround (27) button several
times to set the desired sound effect.
The respective setting will appear on the display.
If no surround sound effect has been selected, then the
audio will be emitted in stereo.
Settings
Adjusting bass and high-range tones
In addition to the sound effects, you can also increase or
decrease the bass and high-range tones individually.
1. Push the button Tone (31) several times if necessary.
You will either see the setting for the bass tones (e.g.
BASS +2) or for the high-range tones (e.g. TREB -1) on
the display.
2. With the buttons + /
– (30)
, adjust the respective setting
to your taste.
Adjusting the subwoofer volume
Adjust the subwoofer volume with the buttons Sub +/
(30).
Display brightness
Push the button Dimmer (28) several times if necessary
in order to set one of the display’s 3 brightness levels.
Lip Sync
During playback of movies, the picture and sound are not
synchronous sometimes. You can eliminate this bother-
some effect with your Cinebar 21.
Push the button Lip Sync (29) and then adjust the delay
between the picture and sound using the buttons +/–
(30). Values can be adjusted between 0 and 200 ms.
11 13
14
15
1618
19
20
21
17
12